This is a quick overview of how to install our flat back crown moldings.
Our CCM and NM moldings install a little differently.
Go to "questions and answers" for more information about each molding.

Call us or order online inside or outside corners at any degree. You can cut your own corners.
See our how to cut crown molding videos.

Check your corner angles with our paper angle finder or purchase one on our online store.

Survey your room for how many corners
 and how much molding you will need.

Now you can apply adhesive to the back of
the corners and intall into the corners. 
If you cut your own molding pre-cuts corners are not needed.

Now you can apply adhesive to the back of
 the corners and molding for mounting.
 See our how to install info and videos.

Paint your molding with a good water-based paint.
You can brush or spray on.
"No spray cans"
See our how to paint information.

You can cut moldings with a kitchen knife or our pull saw.
A electric miter saw works best.

Now you can measure the distance between
 the corners and cut your molding to fit.

 Crown Molding Solutions offers inexpensive Flexible crown moldings, Foam crown moldings.
Ornate crown mouldings, Polyurethane crown moldings, Ceiling medallions,
Floor base moldings, Chair rail moldings and Installation products.
909 North Nolan River Road Suite E, Cleburne, Texas 76033
800 315 6311     Fax 817 641 6711