Creative Crown makes it a snap to install 8" and 13" foam crown moldings


Our "T" and " Wall block system lets you install large moldings without nails or screws.

You can paint your molding before you install it.

You can cut corners yourself or we can cut corners for you, in either inside or outside at any degree.

Mount the snap blocks around the room about every 2 feet. (Cut 2" long blocks)

Just apply our Creative Crown wall adhesive to the back and top of the snap blocks

and mount them to the wall. Allow 1 hour for the adhesive to setup.

Next lay out the moldings with the snap blocks that you just mounted to the wall.

Next, apply hot glue to the "T" and press to the back of the molding

at the same spacing as the snap blocks.

Next, apply adhesive to the bottom and top ledge of the molding and snap into the blocks.

Press the "T" into the snap blocks that are mounted on the wall.

You can apply a little adhesive on the end of the "T" that goes into the snap block.

Also watch our videos Seams/Joints and Glue Corners/Mounting.

 Hot glue the T to the back of the molding even with the top. The tapered edge goes up
and the square edge of the T goes down. Use a low temp glue gun. About 250 degress F.

This "T" presses into the "wall block"  that
is pre-glued to the wall with adhesive.

This "T" mounts to the back of the crown
molding top and will press into the wall block.

Creative Crown offers inexpensive Flexible crown moldings,  Foam crown moldings.
Ornate crown mouldings, Polyurethane crown moldings, Ceiling medallions,
Floor base moldings, Chair rail moldings and Installation products.

Creative Crown  TM
1265 West Kilpatrick Street, Cleburne, Texas 76033
800 315 6311     Fax 817 641 6711