Molding adhesives
Creative Crown Interior/Exterior Foam Adhesive is
strong and fast bonding. Holds on contact in 10 to 15 minutes.
Adheres to most surfaces:
Painted walls, sheetrock, brick, glass, tile, foam, marble, wood, granite,
stucco, steel, vinyl, sheet metal aluminum, plastics and concrete.
No Solvents - Very low VOC's.
Use on all flat back crown moldings, 8", 13", vaulted, chair rail and floor / base moldings.
Use on all NM, CCM crown moldings, wall paper border moldings,corner blocks
and quarter round. Use on all moldings for the top and bottom horizontal seams.
Apply a pencil sized zig zag bead across the back of the molding and apply to the wall.
Press to the wall with the flat palm of your hand.
Install Power Grab the same way.
Power Grab by Loctite adhesives can be used.
Light to medium bonding it dry's in about 1-1/2 hours
Only good for interior sheetrock and painted surfaces.
They setup or bond 3 times longer than Creative Crown
wall adhesive and sealant to bond.
**** WARNING DO NOT USE THESE PRODUCTS ****
ON ANY STYROFOAM OR POLYURETHANE MOLDINGS
THEY ARE HIGH IN VOC'S AND SOLVENTS
Creative Crown offers inexpensive Flexible crown moldings, Foam crown moldings.
Ornate crown mouldings, Polyurethane crown moldings, Ceiling medallions,
Floor base moldings, Chair rail moldings and Installation products.
Creative Crown TM
1265 West Kilpatrick Street, Cleburne, Texas 76033
800 315 6311 Fax 817 641 6711